  /**
  @addtogroup SPI_FullDuplex SPI_FullDuplex for MDR1986VE91 evaluation board
  @latexonly
  @verbatim
  ******************** (C) COPYRIGHT 2024 Milandr ******************************
  * @file    readme.txt
  * @author  Milandr Application Team
  * @version V2.0.1
  * @date    08/11/2024
  * @brief   Description of the SPI_FullDuplex Example.
  ******************************************************************************
  * THE PRESENT FIRMWARE IS FOR GUIDANCE ONLY. IT AIMS AT PROVIDING CUSTOMERS
  * WITH CODING INFORMATION REGARDING MILANDR'S PRODUCTS IN ORDER TO FACILITATE
  * THE USE AND SAVE TIME. MILANDR SHALL NOT BE HELD LIABLE FOR ANY
  * DIRECT, INDIRECT OR CONSEQUENTIAL DAMAGES RESULTING
  * FROM THE CONTENT OF SUCH FIRMWARE AND/OR A USE MADE BY CUSTOMERS OF THE
  * CODING INFORMATION CONTAINED HEREIN IN THEIR PRODUCTS.
  ******************************************************************************
  @endverbatim
  @endlatexonly
  
@par Example Description

This example provides a description of how to set a communication between SPI1 and SPI2 in full-duplex mode and performs a
transfer from Master to Slave.
Both SPIs are configured with 16bit data frame and a 7Kbit/s communication speed.
The master SPI1 starts the SrcBuf1 transfer while the slave SPI1 transmit SrcBuf2. Once the transfer is
completed a comparison is done and TransferStatus1 and TransferStatus2 gives the data transfer status for each data transfer
direction where it is PASSED if transmitted and received data are the same otherwise it is FAILED.


@par Directory contains:

    - main.c     Main program


@par Hardware and Software environment:

    - This example is intended to run on MDR1986VE91 eval board with MDR1986VE91 microcontroller.
    - Connect SSP1 FSS pin (X32.1.26) to SSP2 FSS pin (X32.1.15).
    - Connect SSP1 CLK pin (X32.1.29) to SSP2 CLK pin (X32.1.16).
    - Connect SSP1 RXD pin (X32.1.30) to SSP2 TXD pin (X32.1.20).
    - Connect SSP1 TXD pin (X32.1.31) to SSP2 RXD pin (X33.2.13).
    - HSE oscillator is used so it should be present.


@par How to use.

To launch the example, you must do the following:
  - Create a project and setup all project configurations.
  - Add main.c file.
  - Add the required files from "Libraries" folder:
        MDR32F9Qx_config.h
        MDR32F9Qx_port.c
        MDR32F9Qx_rst_clk.c
        MDR32F9Qx_ssp.c
        MDR32F9Qx_dma.c
  - Edit the MDR32F9Qx_config.h to set appropriate run-time parameter checking level.
  - Compile and link together all .c files and load your image into the target board.
  - Run the example.

 * <h3><center>&copy; COPYRIGHT 2024 Milandr</center></h3>
 */

